User guide

FORMS DESCRIPTION LANGUAGE
XEROX DOCUPRINT 180 LPS FORMS CREATION GUIDE 3-7
Using B4 paper size
When B4 size paper is specified in centimeters, the value should be
rounded off to 25.71 CM. This is only necessary when your GRID
statement is GRID [UNIT] [IS] INCHES.
Using B5 paper size
B5 (7.17 by 10.12 inch) paper size capability is an option which
requires a retrofit kit. When any paper size of less than the minimum
(7.17 by 10 inches) or greater than the maximum (17 by 14.33
inches) is specified in the FSL, the form does not compile and the
following error message appears:
Invalid paper size
When no paper size is specified When there is no PAPER [SIZE] command specified in the FSL, the
DocuPrint 180 uses the sysgened paper size as the default. The
sysgen process does not check for the minimum nor the maximum
paper size. Therefore, if you sysgen the DocuPrint 180 with less than
the minimum or greater than the maximum paper size than its IOT
can support, the DocuPrint 180 compares the sysgened paper size
to the IOT-supported minimum/maximum paper size and if the
sysgened paper size is out of the IOT-supported minimum/maximum
paper size range, the following error message appears:
Sysgened paper size is out of range
Loading unsupported paper sizes If an FRM file specifies a paper size that is not supported by the IOT,
the DocuPrint 180 aborts the job before any printing takes place and
displays the following error message:
Invalid paper size