User guide

UTILITIES WINDOW
5-6 XEROX DOCUPRINT 180 LPS PC UI REFERENCE
File ID (FID)
Use the File ID window to create a prototype (template) command
file.
Figure 5-5. Utilities>File ID window
Parameters Disk ID: DPO
, DP1, DP2, DP3. Select/enter the system disk which
the file will be created on.
File ID: Select/enter the file name and file type of the prototype
command file to be created. If the file ID contains only the file name,
the file is generated using a command file extension (.CMD). If both
the file name and file type are used, the file that is created contains
only the name and type specified.
File Type: Select/enter the specific file directory type from which the
individual records of the command file are to be built. These records
may be edited to produce a command file for manipulating a subset
of file type (for example, deleting a subset of the current fonts in the
FNT directory).
Note: A message displays when the task is complete.
Dump
The Dump utility lists the contents of a file. The listing can be a range
of disk or tape blocks.
The Dump utility does not have an options window. Tasks are
performed by keying in commands in a command line.
The system must be idle and you must have the appropriate logon
level to access this utility.