User guide

SYSTEM CONTROL WINDOWS
XEROX DOCUPRINT 180 LPS PC UI REFERENCE 8-37
occur in BAR ALI mode. Sequence errors are detected as soon as
the controller reports the sheet delivery of the page out of sequence.
A STOP command will be issued to the printer if selected. The printer
will finish all of the pages in progress and then stop.
The system is locked up until a selection is made and the Apply/
Close header button is selected. If display is selected the user will
have to close the display select one of the ignore options to continue.
Sequence error is the error that occurs when the actual barcode
scanned does not match the next number in the sequence. Refer to
the
Xerox DocuPrint 180 LPS PDL/DJDE Reference for more
information on how to define sequence data.
Figure 8-33. Audit Log Sequence Error window
• Ignore the error for the rest of the job - This will ignore the error
on this report and all other reports in this job. A CONTINUE
command will be sent to the printer.
• Ignore the error - This will Ignore the error on this report only.
A CONTINUE command will be sent to the printer.
• Display the Log - The Audit Log Display window will appear and
the log with the error will be displayed. After closing the Audit
Log Display window this window will appear again to enable
selecting the desired action.