User guide

SYSTEM CONTROL WINDOWS
8-36 XEROX DOCUPRINT 180 LPS PC UI REFERENCE
Parameters Operation: - These default settings will cause the printer to stop if the
condition occurs.
STOP if Reconciliation Error - Selection of this check box
causes the following window to appear when a Reconciliation
Error is detected. When selected, a STOP command is issued to
the printer. The printer will finish all of the pages in progress and
then stop.
The system is locked up until a selection is made and the Apply/
Close header button is selected. If display is selected the user
will have to close the display select one of the ignore options to
continue.
A reconciliation error is caused by a mismatch of the monetary
value expected and the monetary value received. Refer to the
Xerox DocuPrint 180 LPS PDL/DJDE Reference for more
information.
Figure 8-32. Audit Log Reconciliation Error window
• Ignore the error - This will Ignore the error on this report only.
A CONTINUE command will be sent to the printer.
• Ignore the error for the rest of the job - This will ignore the error
on this report and all other reports in this job. A CONTINUE
command will be sent to the printer.
• Display the Log - The Audit Log Display window will appear and
the log with the error will be displayed. After closing the Audit
Log Display window this window will appear again to enable
selecting the desired action.
STOP if Sequence Error - Selection of this check box causes the
following window to appear when a sequence error occurs. This is a
secondary safeguard in case the IOT does not detect a sequence
error or the operator has set the ’NO SEQ’ command. This will also