User guide

PRINT TASKS WINDOWS
XEROX DOCUPRINT 180 LPS PC UI REFERENCE 6-9
Bin Mode
The Bin Mode window is accessed by selecting the Bin Mode header
button from the Print Tasks/Printer Status window.
Figure 6-6. Print Tasks>Printer Status>Bin Mode window
Note: Options C, D, and E should only appear if the system is
configured for them.
Use the Bin Mode window to select the bin or bins used for stacking
output. Output may also be sent to the sample tray.
Parameters Select one of the following:
AUTO
: This default option causes output to be stacked in bin A first,
then bin B (then C, then D, if configured).
When the selected bin is full, output is automatically sent to the next
empty bin that can accept the paper size. If all output is the same
paper size, all auto switching bins are used.
SAMPLE TRAY A, B, C, D, E: Select an alternate output destination
you want output stacked in first. Selecting E sends output to the
export tray if the system is configured with the bypass transport and
a third-party finishing device.
Note: If the sample tray is selected, all output is delivered there
until the report ends unless you change the stacker bin selection.
If no bin is available that can accept the output paper size, the printer
stops and you must unload the bin(s).
AUTO
SAMPLE TRAY
A
B
C
D
E