Use and Care Manual

check up
cleaning mode
deep
clean
quick
clean (30M)
touch
up (15M)
waffle
track
spiral
track
wall
track
76
Step Three: Touch Sensors
Press the left side of Bob’s bumper and the bar to the left of the word “Check Up”
should light up; press the right side of the bumper and the bar to the right of “Check
Up” should light up.
Press the center of the bumper and both bars on either side of the word “Check Up”
should light up at the same time.
If both bars light up correctly, you may move on to the next step of the checkup test.
Step Four: Charging Station
The charging station must be synced and plugged in for this step of the checkup test.
Next, press the GO! button on Bob’s cover.
Place Bob directly in front of his charging station, about 1 ft away. Keep blOck Plus
away from Bob so its signal does not interfere with the test.
The words “Deep Clean,” “Quick Clean,” and “Touch Up” should be lit on Bob’s
display.
“Deep Clean” and “Touch Up” represent the station’s sensors. If either one of them
fails to light up, then there is likely something wrong with Bob’s charging station.
The word “Quick Clean” represents the signal on Bob’s front. If it fails to light up, then
it is likely Bob needs a new bumper transmitter.
If all three words light up correctly, you may move on to the next step of the checkup test.
74