Use and Care Manual

check up
check up
74 75
Step One: Edge Sensors
The 4 bars above the word “Check Up” should be lit on Bob’s display.
Lift Bob about 6 inches (15 cm) off the ground. You should see the 4 bars turn off.
If all 4 bars turn off while Bob is lifted, place Bob back on the floor and continue on to
the next step without pressing any additional buttons.
Step Two: Wall Sensors
Use a thick, flat, and white surface to imitate a wall and drag it around Bob’s bumper.
The 5 bars below the word “Check Up” should light up one at a time as you move
your imitation wall around Bob’s bumper.
If all 5 bars light up, you may move on to the next step of the checkup test. Do not
press any additional buttons.