Use and Care Manual

check up
check up
64 65
Dark-colored carpeting and certain floor patterns may seem like edges to Bob’s edge
sensors.
If you notice that Bob stops working on your carpet and displays that he feels “some-
thing funny going on” with his edge sensors, then you may need to to temporarily
deactivate them.
To deactivate Bob’s edge sensors:
Deactivate Edge Sensors
Flip Bob’s power switch ON. Hold down
the CHECKUP button on Bob’s cover.
The 4 bars above “Check Up” will begin
to flash on Bob’s screen.
After the 4 bars flash 7 times and remain
still, release the CHECKUP button. The
4 bars above “Check Up” will remain on.
This means Bob’s edge sensors are de-
activated.
1 2
Caution: When the edge
sensors have been de-
activated, Bob will be
unable to detect stairs
or sharp drops.
To reactivate Bob’s edge sensors:
Hold down the CHECKUP button on
Bob’s cover. The 4 bars above “Check
Up” will begin to flash on Bob’s screen.
After the 4 bars stop flashing and dis-
appear, release the CHECKUP button.
Bob’s edge sensors are active again.
1 2