Use and Care Manual

48 49
If you need to keep certain areas out of Bob’s reach, you can use blOck Plus
to cre-
ate up to two digital barriers that Bob will not cross. blOck Plus runs on 4 AA batteries
(not included).
One digital barrier is emitted from the left side of blOck Plus
, and another is emitted
from the front. You may use one or both barriers depending on your preference.
As with Bob’s charging station and remote, you will need to sync blOck Plus
before
using it for the first time.
Located on the back of blOck Plus
, just above the battery cover, are three buttons:
Power button for the left barrier 1
Power button for the front barrier 2
SYNC button 3
blOck Plus
1 2 3
To sync blOck Plus
:
Now that Bob has synced with blOck Plus
, you may use it to section off areas of
your home. You can sync multiple blOcks with Bob.
Press the button on the far
left, and the power light on
the left side of blOck Plus
will turn on, stay still for 10
seconds, and then slowly
blink every 3 seconds.
This means the blOck’s
left barrier is ON and
ready to sync.
Hold down the blOck’s
sync button on the far
right while at the same
time flipping Bob’s power
switch ON. Bob will chirp
twice to let you know the
sync was successful.
Press the button in the cen-
ter. Now the power light on
the front side of blOck Plus
will turn on, stay still for 10
seconds, and then slowly
blink every 3 seconds.
This means the blOck’s
front barrier is ON and
ready to sync.
1 2 3