Spec Sheet

The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. B-710 Rev. 4/27/11

R/A

Printed in U.S.A.

OPERATION:

No-touch operation. Electronic sensor automatically turns dryer on when hands are held under air-outlet opening and across path of

sensor. Remove hands from path of sensor and dryer stops. Dryer will not stop by itself before user is satisﬁ ed hands are dry. Dryer

operates only when actually drying hands, which saves energy and operating costs. Electronic sensor will automatically shut dryer

off two minutes after dryer turns on if an inanimate object is placed across sensor lens. After inanimate object is removed, electronic

sensor automatically resets itself and dryer operates normally.

1-Year Limited Warranty — This warranty is limited to the repair or exchange of defective parts at the option of Bobrick. See

Installation Instruction Sheet, Form No. 710-69, for full details.

INSTALLATION:

Wall Preparation: Secure mounting base on wall using template provided. For masonry walls, provide four #10 expansion shields or

anchors and secure with four #10 (M4.8) sheet-metal screws (not furnished). For plaster or dry wall construction, provide concealed

backing to comply with local building codes, then secure unit with four #10 (M4.8) round-head sheet-metal screws or 3/16" (5mm)

toggle bolts (not furnished). Provide electrical service from nearest distribution panel to dryer mounting base in compliance with local

electrical codes.

Wiring Instructions:

Connect ground wire to ground terminal marked , the black or hot wire to terminal marked L1, and neutral or white wire to

terminal marked N. A DEDICATED LINE IS REQUIRED FOR EACH 115-VOLT INSTALLATION.

Notes: Electronic sensor in CompacDryer will pick up movement within 4" (100mm) of air-outlet nozzle. Use caution when choosing

location for CompacDryer in conﬁ ned areas. Consider proximity to doorways and other trafﬁ c areas.

Bobrick automatic hand dryers should be installed 15" (380mm) above any projection or horizontal surface which may interfere with

the operation of the automatic sensor.

For installation instructions that include step-by-step installation procedures and details of electrical service connections, see Form

No. 710-69, which is packed with each shipment. This form is also available in advance upon request.

SPECIFICATION:

Surface-mounted hand dryer shall have a one-piece, ﬁ re-retardant molded, Bobrick grey color #889. Mounting base and fan housing

shall be ﬁ re-retardant molded grey plastic with high-gloss ﬁ nish. Brushless motor shall be 90 watts, external rotor type with sealed

ball bearings on ends of drive shaft and be equipped with an automatic thermal-overload switch. Centrifugal fan shall have multiple

metallic vanes. Heating element shall be located on inlet side of fan, shall heat without hot spots, be inaccessible to vandals, and

protected by an automatic thermal-overload switch. Electronic sensor shall automatically turn dryer on when hands are held under air-

outlet opening and across path of sensor. Dryer shall turn off automatically when hands are removed. Sensor shall automatically shut

dryer off approximately two minutes after dryer turns on if an inanimate object is placed across sensor lens. After inanimate object

is removed, electronic sensor shall automatically reset itself and dryer shall operate normally. Unit shall be cULus listed. Unit shall

comply with EU Directive “Restriction of Hazardous Substance” (ROHS) requirements for non-use of certain hazardous substances in

the production of electronic products. Unit shall be protected by a limited 1-year warranty on all parts.

Surface-Mounted Automatic Hand Dryer shall be Model B-710 115V of Bobrick Washroom Equipment, Inc., Clifton

Park, New York; Jackson, Tennessee; Los Angeles, California; and Bobrick Washroom Equipment Company,

Scarborough, Ontario; Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick Washroom Equipment

Limited, United Kingdom.