Installation Sheet
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. Revised 8/10/18 Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2018 by Bobrick Washroom Equipment, Inc.
Technical Data
6-1/8''
155mm
5''
125mm
6-1/8''
155mm
Finish Face of Wall
1-7/8''
50mm
1-7/8''
50mm
5''
125mm
Mounting Clamp
Countersunk
Mounting
Holes (2)
9/16''
14mm
Typ.
Specify Model Required:
Model B-667 Bright polished stainless steel
Model B-6677 Satin-finish stainless steel
Rough Opening
5-1/2" (140mm) wide
5-1/4" (135mm) high
3-3/8" (85mm) minimum
recessed depth
MATERIALS:
Shell and Flange — 18-8, Type-304, 22-gauge (0.8mm) stainless steel. Drawn, one-piece, seamless construction with two
countersunk mounting holes.
Support Posts (2) — Heavy-duty cast zamak with chrome-plated finish.
Mounting Bracket — Plated steel mounting clamp attaches to back of unit with two sheet-metal screws for installation in stud
wall construction and countertop aprons.
Spindle — Chrome-plated plastic equipped with heavy-duty internal spring.
Designer's Note: Theft-resistant toilet tissue spindle, which is removable only with special key provided, are available as an
optional accessory - part no. 283-604.
INSTALLATION:
Provide framed rough opening 5-1/2" wide x 5-1/4" high (140 x 135mm). Minimum recessed depth required from finish face of
wall or apron is 3-3/8" (85mm).
For installation in stud wall construction and countertop aprons without backing: Loosely attach mounting clamp to back of unit
with sheet-metal mounting screws. Insert into rough opening. Adjust mounting clamp so it grips surface inside rough opening.
Secure in place by tightening two sheet-metal mounting screws.
For installation in stud wall construction and countertop aprons with backing: Discard mounting clamp furnished with unit. Insert unit
only into rough opening and secure with sheet-metal screws furnished. Backing must comply with local building codes.
SPECIFICATION:
Recessed toilet tissue dispenser shall be constructed of Type-304, 22-gauge (0.8mm) stainless steel with __________ (insert
one: bright polished or satin) finish. Shell and flange shall be drawn, one-piece, seamless construction. *Spindle shall be
equipped with a heavy-duty internal spring. Unit shall be furnished with plated steel mounting clamp for stud wall construction
and countertop aprons.
*Theft-resistant spindle (part No. 283-604) available as a replacement part.
Recessed Toilet Tissue Dispenser shall be Model __________ (insert model number) of Bobrick Washroom
Equipment, Inc., Clifton Park, New York; Jackson, Tennessee; Los Angeles, California; Bobrick Washroom
Equipment Company, Scarborough; Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick Washroom
Equipment Limited, United Kingdom.
RECESSED
TOILET TISSUE DISPENSER
(FOR STUD WALL OR COUNTERTOP APRONS)
B-667
B-6677