Installation Sheet

In the U.S.A.: BOBRICK WASHROOM EQUIPMENT, INC.
Los Angeles: 6901 Tujunga Ave., North Hollywood, CA 91605-6213: Tel: [phone], FAX: [phone]
New York: 200 Commerce Drive, Clifton Park, NY 12065-1350; Tel: [phone], FAX: [phone],
or e-mail: [e-mail]
In Canada: BOBRICK WASHROOM EQUIPMENT COMPANY
45 Rolark Drive, Scarborough, Ontario M1R 3B1 • Eastern Canada: Tel: [phone] • FAX: [phone]
• Western Canada: Tel: [phone] • FAX: [phone]
© 2016 by Bobrick Washroom Equipment, Inc.
Form No. 3974-89 Rev. 5/11/16 Printed in U.S.A.
REPLACEMENT FOR AUTOMATIC ROLL TOWEL MODULE
(For units without external LED light) Using 3974-80 Retrofit Kit
Remove the existing Automatic Roll Towel Module and the Towel Mouth.
1. Attach 3974-81 Retrofit Cover to the bottom of the Cabinet using provided 5262-133 Screws and 43944-75 Lock
Washers.
2. Install 3974-82 Towel Mouth/Sensor Assembly by using 3974-14 Key Hole Clips. Towel Mouth should overlap
3974-81 Retrofit Cover slightly with the Activation Sensor Connector and Wire placed inside the Cabinet.
Take care at all times to not pinch the Activation Sensor Wire.
3. Install the new Automatic Roll Towel Module in cabinet using 5262-133 Screws and 43944-75 Lock Washers.
Ensure that all 5262-133 screws are securely installed.
4. Connect the Automatic Roll Towel Module Connector to the Activation Sensor Connector.
Automatic Roll
Towel Module
Connector
Activation
Sensor Connector
Automatic Roll
Towel Module
3974-82
Towel Mouth/
Sensor Assembly
5262-133 Screw
43944-75 Washer
3974-14
Key Hole Clip
3974-14
Key Hole Clip
3974-81
Retrofit Cover
3974-82
Towel Mouth/
Sensor Assembly
5262-133 Screw
43944-75 Washer
3974-81
Retrofit Cover
3.
2.
Cabinet
Activation
Sensor Wire
1.
4.