Installation Sheet

The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. B-3474 Rev. 4/24/20
R/A, S/D
Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2020 by Bobrick Washroom Equipment, Inc.
INSTALLATION:
Provide framed rough wall opening 16" wide x 29-1/4" high (405 x 745mm). Mini mum recessed depth required from
finish face of wall is 4" (102mm). Top of wall opening should be 42-3/8" (1075mm) and installation of 18" vertical grab bar
(ICC A117.1-2009) from finish face of floor to allow placement of horizontal grab bar at 33" (840mm) height across front of
unit. Allow clearance for construction features that may protrude into rough wall opening from opposite wall. Coordinate
with mechani cal engineer to avoid pipes, vents, and conduits in wall. If unit projects above top of wainscot, provide aluminum
channel or other filler to eliminate gap between flange and finish face of wall. Mount unit in wall opening with shims between
framing and cabinet at all points indicated by an S, then secure unit with #8 x 1-1/4" (4.2 x 32mm) sheet-metal screws
(not furnished).
Designer’s Notes:
1. Recessed B-3474 mounts flush against side wall in accessible toilet compartment and has toilet tissue dispenser on right
side of unit.
2. Position unit on panel with centerline of toilet tissue dispenser 7" - 9" (180 - 230mm) in front of leading edge of toilet.
3. For unit to mount on right side of toilet (when seated on toilet) see model B-34745.
4. For visual placement of models inside toilet compartment, refer to Technical Bulletin TB-92.
SPECIFICATION:
Recessed toilet seat-cover and toilet tissue dispenser shall be Type-304 stainless steel with all-welded construction; exposed
surfaces shall have satin finish. Toilet tissue dispenser shall be ABS plastic. Flange shall be drawn and beveled, one-piece,
seamless construction. Unit shall mount flush against side wall in accessible toilet compartment to allow clearance for grab bar
across front of unit and installation of 18" vertical grab bar (ICC A117.1-2009). Doors shall be one-piece, seamless construction;
secured to cabinet with a full-length stainless steel piano-hinge; and equipped with a tumbler lock keyed like other Bobrick
washroom accessories. Toilet seat-cover dispenser holds 500 paper covers. Unit shall be equipped with two theft-resistant,
heavy-duty ABS toilet tissue spindles that hold standard-core rolls up to 5-1/4" (135mm) diameter (1800 sheets). Spindles shall
be removable when door is open.
Recessed Seat-Cover And Toilet Tissue Dispenser shall be Model B-3474 of Bobrick Washroom Equipment, Inc.,
Clifton Park, New York; Jack son, Tennessee; Los Angeles, California; Bobrick Washroom Equipment Company,
Scarborough, Ontario; Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick Washroom Equipment
Limited, United Kingdom.