Specification Sheet

The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. Revised 12/22/16 Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2016 by Bobrick Washroom Equipment, Inc.
Technical Data
BOBRICK
S
S
3''
75mm
7-5/8''
195mm
1-1/4''
30mm
Minimum Clearance Required
2-3/4''
70mm
4-1/8''
105mm
4''
100mm
3''
75mm
Container
Bracket
Collar
Valve
Recommended Mounting Height Off Floor
For Universal / Accessible Design
51-5/8'' 1311mm
MATERIALS:
Bracket and Collar — Bright polished chrome-plated ABS.
Container — Translucent, shatter-resistant polyethylene. Capacity: 24-fl oz (0.7-L).
Valve — Grey ABS with stainless steel spring. Corrosion-resistant.
OPERATION:
Push valve up to dispense measured amount of thin, free-flowing commercially marketed all-purpose hand soaps, non-iodine based
soaps and do not use alcohol based sensitizers. Valve operates with one hand, without tight grasping, pinching, or twisting of the wrist,
and with less than 5 pounds of force (22.2 N) to comply with accessible design (including ADAAG in U.S.A.). Only after the collar is
unscrewed at base of unit can the valve be removed from the container for filling. Translucent container provides visible soap level.
INSTALLATION:
Secure dispenser to the wall with four sheet-metal screws, furnished by manufacturer, at points indicated by an S. For plaster or dry
wall construction, provide concealed backing to comply with local building codes, then secure with sheet-metal screws furnished. For
other wall surfaces, provide fiber plugs or expansion shields for use with sheet-metal screws furnished, or provide 1/8" (3mm) toggle
bolts or expansion bolts.
Note: Provide 1-1/4" (30mm) minimum clearance from cap to underside of any horizontal projection. Valve should be located 44"
(1120mm) maximum above the finish floor.
SPECIFICATION:
Soap dispenser shall have bright polished chrome-plated ABS bracket and collar. Corrosion-resistant valve shall dispense thin, free-
flowing commercially marketed all-purpose hand soaps. Valve shall be operable with one hand and with less than 5 pounds of force
(22.2 N) to comply with accessible design (including ADAAG in U.S.A.). Container shall be translucent, shatter-resistant polyethylene
with a capacity of 24-fl-oz (0.7-L).
Liquid Soap Dispenser shall be Model B-155 of Bobrick Washroom Equipment, Inc., Clifton Park, New York; Jackson,
Tennessee; Los Angeles, California; Bobrick Washroom Equipment Company, Scarborough, Ontario; Bobrick Washroom
Equipment Pty. Ltd., Australia; and Bobrick Washroom Equipment Limited, United Kingdom.
B-155
LiquidMate
®
LIQUID SOAP
DISPENSER