Installation Sheet

SPRING LOCK

SIDE

SET

SCREW

SIDE

Spout Replacement

To replace spout body, you must rst turn water o󰀨, then remove spout with sensor cable.

With screws removed, the electronics box can slide o󰀨 and allow

access to the solenoid for service

Loosening screw will cause sensor assembly to back out of

spout body. It may be necessary to push cable from connector

end to aid in sensor assembly removal. Firmly press into pocket

and tighten screw. Sensor connector may need to be turned

horizontally when rst inserting into the spout.

Align spout so that the ball detent is between the 2 holes. Press

down and turn clockwise. Use hex wrench to back set screw out

to secure spout

Lift spout and pull sensor cable through deck and base

Note location of set screw and spring lock.

Accessing the Solenoid

To service solenoid use Phillips head screw driver to remove the

screws on both sides of the electronics box

Sensor Assembly Replacement

With spout disengaged, sensor assembly can now be removed

by loosening the center screw with supplied M3 Allen wrench.

With assembly removed, you can now install new assembly and

reassemble your spout.

To reinstall faucet, rst drop sensor cable of new spout through

the front of the base. Lower spout onto base inserting base

nipple into spout port.

Use supplied 3/32" hex wrench to loosen set screw. Screw

will retract into the base to eliminate loss. Using the same hex

wrench, depress the ball detent to release spout from base.

Before removing the spout, disconnect the sensor cable below

the deck so that the cable head can be pulled up through the deck.

*Take care to press the locking mechanism in prior to

disconnecting sensor cable. PULLING APART WITHOUT

PRESSING IN THE LOCK MAY DAMAGE THE SENSOR OR

CONTROLLER CABLES.