Installation Sheet

Form No. 8878-69 (Revised 3/10/20) © 2020 Bobrick Washroom Equipment, Inc. Printed in U.S.A.
3
Installation
NOTE: Before installation, turn o󰀨 water supplies to existing faucet and remove faucet if replacing an existing device. Clean the
faucet basin and clear away debris. Flush all supply lines before connecting the faucet. Failure to do so may result in debris clogging
the inlets and/or internal control and mixing valve
Spout Installation - Step 1
1.1. Carefully screw aerator into spout using included tool.
Take care to not pinch blue o-ring
1.2.
Install spout to sink using spout base gasket, plastic mounting
washer, star washer and mounting nut (and cover plate for
versions that are included) .
Electronics Module Installation - Step 2
2.1. Assemble the electronics module.
2.1a. For non-IM assembly, connect lter to bottom of
electronics module.
Sensor cable should not pass through plastic
mounting washer.
1.3. Ensure that slot in plastic washer is facing forward
2.2.
Open battery module using supplied Allen wrench and install
supplied batteries in the electronics module