User's Manual

6.2 Configure network connection
6.2.1 Equipment assembly
Open the package, take out the device, power adapter and antenna, insert the SMA male connector
of the antenna feeder into the LongFi antenna port of the device and tighten it.
6.2.2 Set up distribution network
Open the Helium App in your phone, register to enter, and select "Set up Hotspot".
Then select Bobcat Miner 300 equipment to enter, you can read the network configuration
instructions first, or select "Skip" to operate step by step according to the prompts on the page.
Insert the AC plug end of the power adapter into the 220VAC mains socket, and the other end of
the DC12V output plug into the power jack of the device, as shown in the figure below. After
plugging in the power, the LED of the gateway turns red and then yellow.