Service Manual

325/328 Excavator
Operation and Maintenance Manual 40
ATTACHMENTS (CONT’D)
Using The X-Change System (Cont’d)
Removing Bucket Or Attachment (X-Change System)
The excavator is equipped with the X-Change system.
The X-Change is used for fast changing of buckets and
attachments.
NOTE: Removal and installation of the bucket is
shown. The procedure is the same for other
attachments. Disconnect any hydraulic lines
that are operated by hydraulic power before
removing any attachments (breaker, auger,
etc.).
WARNING
Never use attachments or buckets which are not
approved by Bobcat Company. Buckets and
attachments for safe loads of specified densities are
approved for each model. Unapproved attachments
can cause injury or death.
W-2052-0500
Stop the machine on a flat level surface. Put the bucket
on the ground.
Figure OI-88
Install the X-Change tool (Item 1) [Figure OI-88] in the
latch.
Pull the tool (Item 1) [Figure OI-88] to unlock the latch.
Remove the tool.
Figure OI-89
Start the engine, lift the boom approximately 300 mm and
extend the bucket cylinder until the X-Change pins
(Item 1) engage the hooks (Item 2) [Figure OI-89] on the
bucket.
Figure OI-90
Retract the bucket cylinder and lower the boom and arm
until the bucket is on the ground, and the X-Change pins
(Item 1) are disengaged from the hooks (Item 2)
[Figure OI-90].
Move the arm towards the machine until the X-Change
pins are clear of the bucket.
P19382
1
P19392
2
1
P19393
2
1