Service Manual

325/328 Excavator

Operation and Maintenance Manual 34

ATTACHMENTS (CONT’D)

Using The X-Change System (Cont’d)

Installing Bucket Or Attachment (Bolt On X-Change)

(Cont’d)

Figure OI-77

Raise the boom, and extend the bucket cylinder until the

bucket is in the position shown [Figure OI-77].

With the arm vertical, lower the boom until the hooks

(Item 1) of the bucket disengage the pins (Item 2) of the

X-Change and plate (Item 3) [Figure OI-77] engages in

the bucket crossmember.

Stop the engine. Turn the start key to the ON position and

move both hydraulic control levers to relieve hydraulic

pressure.

WARNING

Keep all onlookers 6 m away from equipment when

operating. Contact with moving parts, a trench

collapse or flying objects can cause injury or death.

W-2119-0788

Figure OI-78

Install the plate (Item 1) [Figure OI-78].

P-49837

P-49718