Service Manual

325/328 Excavator

Operation and Maintenance Manual 32

ATTACHMENTS (CONT’D)

Using The X-Change System (Cont’d)

Installing Bucket Or Attachment (Bolt-On X-Change)

Use the bolt-on X-Change components when

installing older attachments that do not have the pin

retention provision. Bolt-on components are supplied

with the excavator and are stored under the right side

cover.

NOTE: Removal and installation of the bucket is

shown. The procedure is the same for other

attachments. Disconnect any hydraulic lines

that are operated by hydraulic power before

removing any attachments (breaker, auger,

etc.).

WARNING

Never use attachments or buckets which are not

approved by Bobcat Company. Buckets and

attachments for safe loads of specified densities are

approved for each model. Unapproved attachments

can cause injury or death.

W-2052-0500

Figure OI-71

Fully retract the bucket cylinder and lower the arm to the

ground [Figure OI-71].

With the engine off, turn the start key to the ON position

and move both hydraulic control levers to relieve hydraulic

pressure.

Figure OI-72

Remove the three plugs (Item 1) [Figure OI-72].

Figure OI-73

Apply grease to the O-rings (Item 1) [Figure OI-73].

P-49713

P-49714

P-49715