Service Manual

325/328 Excavator
29 Operation and Maintenance Manual
ATTACHMENTS (CONT’D)
Using The X-Change System (Cont’d)
Removing Bucket Or Attachment (Pin On X-Change)
Use the pin on X-Change when installing new
attachments that are equipped with the pin on X-Change
bracket.
NOTE: Removal and installation of the bucket is
shown. The procedure is the same for other
attachments. Disconnect any hydraulic lines
that are operated by hydraulic power before
removing any attachments (breaker, auger,
etc.).
WARNING
Never use attachments or buckets which are not
approved by Bobcat Company. Buckets and
attachments for safe loads of specified densities are
approved for each model. Unapproved attachments
can cause injury or death.
W-2052-0500
Figure OI-66
Park the Excavator on a flat level surface. Put the bucket
on the ground [Figure OI-66].
With the engine off, turn the start key to the ON position
and move both hydraulic control levers to relieve hydraulic
pressure.
P-49838