Service Manual

325/328 Excavator

Operation and Maintenance Manual 28

ATTACHMENTS (CONT’D)

Using The X-Change System (Cont’d)

Installing Bucket Or Attachment (Pin On X-Change)

(Cont’d)

Figure OI-64

Stop the engine. Turn the start key to the ON position and

move both hydraulic control levers to relieve hydraulic

pressure.

Drive the pin (Item 1) [Figure OI-64] through the bucket

mount and X-Change.

Figure OI-65

Install the retainer pin (Item 1) [Figure OI-65].

Check for proper installation.

Lift the attachment and fully extend and retract the bucket

cylinder.

P-49706

P-49708