Service Manual

325/328 Excavator
23 Operation and Maintenance Manual
STARTING THE ENGINE (CONT’D)
Keyless Start
WARNING
AVOID INJURY OR DEATH
• Fasten seat belt, start and operate only from the
operator seat.
• Never wear loose clothing when working near
machine.
W-2135-1188
Perform the PRE-STARTING PROCEDURE. (See PRE-
STARTING PROCEDURE on Page 20.)
Figure OI-54
Move the engine speed control (Item 1) [Figure OI-54] to
low idle.
Figure OI-55
Press ENTER CODE Button (Item 1) [Figure OI-55]. The
display will light up and there will be two short beeps,
CodE will appear on the LCD.
Use the keypad (Item 2) [Figure OI-55] to enter the
password. For each digit that you enter, a dash will
appear on the LCD. (You have 40 seconds to enter the
password or the process will abort and you will need to
start over.) If the password was entered correctly, there
will be one long beep.
NOTE: If the password was incorrect there will be
three short beeps and “Error” will appear on
the LCD. Press the ENTER CODE Button again
and start over. After three failed attempts, you
must wait three minutes to try again.
Press the START Button (Item 3) [Figure OI-55] and hold
it until the engine starts.
IMPORTANT
Do not engage the starter for more than 15 seconds at
a time. Longer use can damage the starter by
overheating. Allow starter to cool down for one
minute before using starter again.
I-2034-0700
Press the STOP button (Item 4) [Figure OI-55] to stop the
engine.
Stop the engine if the warning lights and alarm do not go
OFF.
Check for the cause before starting the engine again.
Password Lockout Feature
See Password Lockout Feature. (See Password Lockout
Feature on Page 95.)
P16615
1
P16616
1
3
4
2