Service Manual

325/328 Excavator
Operation and Maintenance Manual 4
INSTRUMENTS AND CONSOLES (CONT’D)
Right Console
Figure OI-3
Right Control Lever (Joystick) - (Item 1) [Figure OI-3]
(See HYDRAULIC CONTROLS on Page 16.)
Auxiliary Hydraulics Switch - (Item 2) [Figure OI-3]
Controls the fluid flow to the auxiliary quick connectors
(attachment). (See Auxiliary Hydraulics on Page 42.)
Blade Control Lever - (Item 3) [Figure OI-3] Controls
raising and lowering the blade. (See BLADE CONTROL
LEVER on Page 17.)
Two-Speed Button - (Item 4) [Figure OI-3] Engages and
disengages High Range Driving Speed, (See Two-Speed
Driving on Page 7.)
Speed Control Lever - (Item 5) [Figure OI-3] Controls
the RPM of the engine.
Key Switch (STANDARD Panel Only) - (Item 6)
[Figure OI-3] Always perform the PRE-STARTING
PROCEDURE before starting the engine. (See PRE-
STARTING PROCEDURE on Page 20.) (See STARTING
THE ENGINE on Page 22.)
NOTE: Always turn key switch and all accessories to
OFF position when the engine is stopped, the
battery will discharge if the key is left ON.
Audible alarm will sound if the key is in the ON
position with the engine stopped.
Auxiliary Power Outlet - (Item 7) [Figure OI-3] Provides
12 volt receptacle for accessories.
Auxiliary Hydraulic Button - (Item 8) [Figure OI-3]
Activates and deactivates auxiliary hydraulic function.
(See Auxiliary Hydraulics on Page 42.)
HOURS/JOB/RPM - (Item 9) [Figure OI-3] Press to show
HOURS, JOB CLOCK or Engine RPM in LCD (Liquid
Crystal Display, Item 12.) [Figure OI-3] (See Job Clock
on Page 95.)
LIGHTS/HOLD FOR CODES - (Item 10) [Figure OI-3]
Press once to turn lights ON; press again to turn lights
OFF, Press and hold two seconds for display of SERVICE
CODES in LCD (Item 12) [Figure OI-3].
TEMPerature - (Item 11) [Figure OI-3] Shows the engine
coolant temperature.
LCD (Liquid Crystal Display) - (Item 12) [Figure OI-3]
The LCD is the HOURMETER during normal operation of
the Excavator, When preheat is activated (Keyless Start),
the LCD will show remaining preheat time. Can also be
used to display JOB CLOCK or Engine RPM. (See Job
Clock on Page 95.)
FUEL Gauge - (Item 13) [Figure OI-3] Shows the amount
of fuel in the tank.
Keyless Start (DELUXE Panel Only) - (Item 14)
[Figure OI-3] Always perform the PRE-STARTING
PROCEDURE before starting the engine. (See PRE-
STARTING PROCEDURE on Page 20.) (See STARTING
THE ENGINE on Page 22.)
Function Icons - (Item 15) [Figure OI-3] (See Function
Icons on Page 5.)
JOB - (Item 16) [Figure OI-3] On when JOB CLOCK is
activated.
RPM - (Item 17) [Figure OI-3] On when Engine RPM is
activated.
P-49175B
8
9
10
11
16
17
12
15
13
14
DELUXE Panel Shown
STOP
ON
START
7
5
3
4
2
1
6
STOP - Key switch OFF; engine stopped
ON - Position when the engine is running.
START - Start engine.