Service Manual

325/328 Excavator
93 Operation and Maintenance Manual
DIAGNOSTICS SERVICE CODE
Number Codes List
CODE CODE
02-16 Hydraulic charge filter not connected 20-02 Two speed output error ON
02-17 Hydraulic charge filter plugged 20-03 Two speed output error OFF
03-09 Battery voltage low 21-02 Glow plug output error ON
03-10 Battery voltage high 21-03 Glow plug output error OFF
03-11 Battery voltage extremely high
03-14 Battery voltage extremely low 22-02 Starter relay output error ON
03-22 Battery voltage out of range low 22-03 Starter relay output error OFF
04-14 Oil pressure extremely low 26-02 Front base output error ON
04-15 Oil pressure shutdown level 26-03 Front base output error OFF
05-09 Hydraulic charge pressure low 27-02 Front rod output error ON
05-14 Hydraulic charge pressure extremely low 27-03 Front rod output error OFF
05-15 Hydraulic charge pressure shutdown level
05-21 Hydraulic charge pressure out of range high 28-02 Diverter output error ON
05-22 Hydraulic charge pressure out of range low 28-03 Diverter output error OFF
06-10 Engine speed high 30-28 Watch dog failure
06-11 Engine speed extremely high
06-15 Engine speed shutdown level 31-28 Recovery mode failure
06-18 Engine speed out of range high
33-23 Controller not calibrated
07-10 Hydraulic oil temperature high
07-11 Hydraulic oil temperature extremely high
07-15 Hydraulic oil temperature shutdown level 60-21 Sec. aux. thumbswitch out of range high
07-21 Hydraulic oil temperature out of range high 60-22 Sec. aux. thumbswitch out of range low
07-22 Hydraulic oil temperature out of range low 60-23 Sec. aux. thumbswitch not calibrated
08-10 Engine coolant temperature high 62-04 Load moment monitoring in error
08-11 Engine coolant temperature extremely high
08-15 Engine coolant temperature shutdown level 63-05 Work group/drive console sensor
08-21 Engine coolant temperature out of range high 63-06 Work group/drive console sensor
08-22 Engine coolant temperature out of range low
64-05 Switched power/acc. relay short to battery
09-09 Fuel level low 64-06 Switched power/acc. relay short to ground
09-21 Fuel level out of range high 64-07 Switched power/acc. relay open circuit
09-22 Fuel level out of range low
65-02 Work group/drive lockout solenoid error ON
12-21 Primary auxiliary PWM switch out of range high 65-03 Work group/drive lockout solenoid error OFF
12-22 Primary auxiliary PWM switch out of range low 65-05 Work group/drive lockout solenoid short to battery
12-23 primary auxiliary PWM switch not calibrated 65-06 Work group/drive lockout solenoid short to ground
65-07 Work group/drive lockout solenoid open circuit
13-05 Fuel shut-off hold solenoid short to battery
13-06 Fuel shut-off hold solenoid short to ground 66-05 Drive solenoid short to battery
66-06 Drive solenoid short to ground
14-02 Fuel shut-off hold solenoid short to batter
14-03 Fuel shut-off hold solenoid short to ground