Service Manual

325/328 Excavator

Operation and Maintenance Manual 84

DRIVE MOTOR

Checking Oil Level

Figure PM-50

Park the excavator on a level surface with the plugs (Item

1 and 2) [Figure PM-50] in the position as shown.

Remove the plug (Item 1) [Figure PM-50]. The lube level

must be at the bottom edge of the hole.

Add lubricant through the hole if the lube level is low.

Draining The Drive Motor

See the SERVICE SCHEDULE for the correct service

interval. (See SERVICE SCHEDULE on Page 59.)

Park the excavator on a level surface with plugs (Item 1

and 2) [Figure PM-50] in the position shown. Remove

both plugs and drain the lubricant into a container.

WARNING

Always clean up spilled fuel or oil. Keep heat, flames,

sparks or lighted tobacco away from fuel and oil.

Failure to use care around combustibles can cause

explosion or fire which can result in injury or death.

W-2103-1285

Install the bottom plug (Item 2 [Figure PM-50]). Add

lubricant through the top plug hole until the lube level is at

the bottom edge of the hole.

Install the plug (Item 1) [Figure PM-50].

P-49184