Service manual

CONTROL PEDALS

Removal And Installation

Remove the bolt and nut (Item 1) [A] from the pedal

linkage.

Installation: Tighten the bolt and nut to 21–25 ft.–lbs.

(28–34 Nm) torque.

Check the rubber bushing in the pedal for wear and

replace as needed.

Remove the two mounting bolts (Item 1) [B].

Remove the pedal assembly from the loader.

Pedal Adjustment

After installing the pedal, adjust the pedal so that there is

clearance under the rear of the pedal and the valve spool

must travel full stroke without hitting the floor panel.

W–2104–1285

Adjust locking tabs on pedal control linkage so

that lift and tilt control pedals are locked in

neutral when the seat bar is up.

AVOID INJURY OR DEATH

NOTE: See Page 2–44 for correct procedure to

adjust the pedal interlock linkage.

P–04771

–2–42–

853, 853H BICS Loader

Service Manual

P–04770