Service manual

SELECT VALVE (S/N 512811001 & Above) W/Select

Valve (JEM) (Cont’d)

Removal And Installation (Cont’d)

Remove the mounting bolts (Item 1) [A] located on the

outside left frame.

Remove the select valve.

Disassembly And Assembly

Clean the select valve to remove dirt before disassembly.

When repairing hydrostatic and hydraulic

systems, clean the work area before

disassembly and keep all parts clean. Always

use caps and plugs on hoses, tubelines and

ports to keep dirt out. Dirt can quickly damage

the system.

I–2003–0888

Remove the solenoid valve coils in Fig. [B].

NOTE: The controls wiring harness colors are listed

below for identification during select valve

assembly installation.

Second aux. male coupler (Item 1) [B] Yellow/Brown

Second aux. female coupler (Item 2) [B] Yellow/Lt. Green

High Flow (Item 3) [B] Lt. Blue/Red

Second aux. diverter (Item 4) [B] Yellow

Assembly: The coils largest opening (Item 1) [C] must

position on the valve shoulder (Item 2) [C]. Install the

washer (Item 1) [D] between the double coils. Install the

coils and tighten the nuts (Item 2) [D] to 5 ft.–lbs. (6,7 Nm)

torque.

P–09190

P–09177

P–09194

853, 853H BICS Loader

–2–33– Service Manual

P–09184