Service manual

SELECT VALVE (S/N 512811001 & Above) W/Select
Valve (JEM) (Cont’d)
Removal And Installation
Raise the operator cab. (See Page 1–1.)
Remove the bolt (Item 1) [A].
Disconnect the controls harness at the left side steering
lever connectors (Item 2) [A].
If so equipped disconnect the attachment harness from
the controls harness and the left side steering lever
connectors. Put the relay assembly (Item 3) [A] and
attachment harness aside.
Remove the front mount nut and steering panel brace
(Item 4) [A].
Disconnect the controls harness from the select valve
connectors (Item 1) [B].
Remove the rear bolt (Item 2) [B] on the left side pedal link
(Item 3) [B].
Remove the link front bolt and push the link (Item 3) [B]
forward.
Disconnect and remove the tubeline (Item 1) [C].
Disconnect and lower the tubeline (Item 2) [C].
Disconnect the tubeline (Item 3) [C].
Disconnect the hose (Item 4) [C].
Disconnect the tubelines (Item 1) [D] at the select valve.
Install caps and plugs on open connections.
Remove the select valve.
Installation: Connect controls harness to select valve
solenoids. Refer to the Electrical Wiring Diagram for the
correct controls harness wire colors.
A
P–09185
2
4
2
3
1
C
P–09187
4
3
2
1
D
P–09186
1
–2–32–
853, 853H BICS Loader
Service Manual
B
P–09189
3
1
1
2