Service manual

HYDRAULIC CONTROL VALVE (Cont’d)
Removal And Installation (Cont’d)
Remove the control valve outlet tubeline (Item1) [A] from
the control valve.
Remove the power beyond tubeline which goes to the
auxiliary control valve inlet [B].
Disconnect the control valve inlet hose (Item 1) [B] which
comes from the outlet of the hydraulic pump.
Disconnect the two connectors from the solenoids on the
auxiliary section of the control valve [C].
Remove the two mounting bolts and remove the control
valve [D].
Installation: Tighten the mounting bolts to 25 ft.–lbs. (34
Nm) torque.
SEE THE COMPONENT REPAIR MANUAL FOR THE
HYDRAULIC CONTROL VALVE FOR THE
DISASSEMBLY AND ASSEMBLY PROCEDURE.
A
CD–10941
1
C
CD–10943
D
CD–10944
853, 853H BICS Loader
–2–29– Service Manual
B
CD–10942
1