Service manual

W–2006–0284
When the engine is running during service, the
steering levers must be in neutral and the
parking brake engaged. Failure to do so can
cause injury or death.
DUAL PRESSURE MAIN RELIEF VALVE (S/N
512811001 & Above) W/Select Valve (JEM) (Cont’d)
Checking The High Setting (Cont’d)
Install the hose (Item 1) [A] on the secondary auxiliary
quick couplers as shown.
NOTE: The High Horsepower switch should be in the
OFF position.
Push the button (Item 1) [C] to engage the detent position
to the front auxiliary quick couplers.
Push and hold the button (Item 2) [C] for fluid flow through
the secondary auxiliary couplers and hose loop.
Watch the flow meter on the hydraulic tester to be sure the
flow is correct.
There should be approximately 18.0 GPM (68,1 L/min.)
free flow. Turn the restrictor control on the tester, until the
main relief valve opens. The correct pressure for the main
relief is 3000 PSI (20685 kPa).
Release the button (Item 2) [C] and push the button (Item
1) [C] to disengage the detent position to the front
auxiliary quick couplers.
If the relief pressure is not correct, stop the engine.
Replace or adjust the main relief valve. (See Page 2–27.)
NOTE: The hose loop (Item 1) [A] (with .070 inch
orifice), provides restriction and pilot
pressure necessary to shift the dual stage
main relief valve to the high pressure setting.
Start the engine and run at low idle RPM. Increase the
engine speed to full RPM. Push the mode switch (Item 1)
[B] twice (on the instrument panel) to engage the front
auxiliary hydraulics detent, the lights (Items 2 & 3) [B] will
come ON.
A
P–05196
1
C
P–00389
P–00391
Left
Steering
Lever
Right
Steering
Lever
Control
Control
1
2
853, 853H Loader
–2–25– Service Manual
B
P–00998
2
1
3