Service manual

TILT CYLINDER (Cont’d)

Removal And Installation (Cont’d)

Remove the retainer bolt and nut (Item 1) [A] from the

base end pivot pin.

Installation: Tighten the retainer nut and bolt to 18–20

ft.–lbs. (24–27 Nm) torque.

W–2103–1285

Always clean up spilled fuel or oil. Keep heat,

flames, sparks or lighted tobacco away from

fuel and oil. Failure to use care around

combustibles can cause explosion or fire

which can result in injury or death.

Remove the base end pivot pin (Item 1) [B].

Remove the tilt cylinder from the loader.

Rod End Seal

Remove the old seal (both sides) from the rod end of the

tilt cylinder.

Install the new seals with the lip facing out [C].

Use two pieces of shim stock to protect the new seals

during installation.

Install the rod end of the tilt cylinder into the Bob–Tach

[D].

Be careful not to damage the new seals during

installation.

CD–15077

P–03911

P–03910

–2–12–

853, 853H Loader

Service Manual

CD–15078