Service manual

Disconnect the hose (Item 1) [A] which goes to the base
end of the tilt cylinder.
Put a plug in the hose and tighten.
Connect a hose between cylinder port and into a drain
pan.
Engage the parking brake. Lower the seat bar. Start the
engine and push the bottom (heel) of the tilt pedal. If there
is leakage from the open port, remove the tilt cylinder for
repair.
Removal And Installation
Remove the attachment. Roll the Bob–Tach fully forward
[B].
Stop the engine. Raise the seat bar.
Disconnect both hydraulic hoses (Items 1 & 2) [A].
Remove the retainer bolt and nut (Item 1) [C] from the rod
end pivot pin.
Installation: Tighten the retainer nut to 18–20 ft.–lbs.
(24–27 Nm) torque.
Remove the grease fitting from the rod end pivot pin.
Remove the rod end pivot pin (Item 1) [D].
TILT CYLINDER
Checking The Tilt Cylinder
Remove the attachment. Roll the Bob–Tach fully back.
Stop the engine. Raise the seat bar.
Diesel fuel or hydraulic fluid under pressure
can penetrate skin or eyes, causing serious
injury or death. Fluid leaks under pressure may
not be visible. Use a piece or cardboard or
wood to find leaks. Do not use your bare hand.
Wear safety goggles. If fluid enters skin or eyes,
get immediate medical attention from a
physician familiar with this injury.
W–2072–0496
A
CD–15074
1
2
C
CD–15076
1
D
P–03904
1
853, 853H Loader
–2–11– Service Manual
B
CD–15075