Service manual

BOSS® INSTRUMENT PANEL
Removal And Installation
Pry the rubber light mount from the operator cab (both
sides) [A].
Lower the light from the operator cab and remove the
three panel mounting bolts (Item 1) [B] (both sides.)
Pull the left panel (Item 1) [C] down from the operator cab.
Installation: Do not overtighten the panel mounting bolts
to prevent stripping the threaded holes of the panels.
Disconnect the wire harness connectors from the panel
and remove the panel.
Remove the three mounting bolts and pull the right panel
(Item 1) [D] down from the operator cab.
Installation: Do not overtighten the panel mounting bolts
to prevent stripping the threaded holes of the panels.
Disconnect the wire harness connectors from the panel
and remove the panel.
A
P–03995
C
P–03958
1
D
P–03959
1
853,853H Loader
–8–9– Service Manual
853, 853H Service Manual #6720755 – BICS System Section
B
P–03955
1
1