Service manual

BOSS® UNIT
Removal And Installation
Raise the loader operator cab. (See Page 1–1.)
Loosen the nuts (Item 1) [A] from the sensing system unit
(Item 2) [A].
Slide the unit forward in the mounting slots and remove
it from the operator cab.
Remove the two connectors (Item 1) [B] from the sensing
system unit (Item 2) [B].
Installation: Put the heads of the mounting bolts into the
slots of the operator cab and slide the unit back into place.
Tighten the three mounting nuts to 80–90 in.–lbs. (9–10
Nm) torque.
A
P–04043
1
2
1
–8–8–
853, 853H Loader
Service Manual
B
P–04042
2
1
1