Service manual

RPM SENSOR

Adjustment

Continuity Resistance of 3000–3500 ohms.

Disconnect the connector [A] from the engine harness.

Loosen the jam nut (Item 1) [A] on the RPM sensor.

Turn the RPM sensor (Item 1) [B] in until it makes contact

with the engine flywheel.

Turn the jam nut until it contacts the flywheel housing. The

jam nut should not be tightened, it needs to turn with the

RPM sensor when the sensor is turned back out for

adjustment.

Turn the RPM sensor and the jam nut out from the

flywheel. Set a clearance of 0.050’’ (1,27 mm) between

the jam nut and the housing with a feeler gauge [B].

Retighten the jam nut.

NOTE: The plastic tip is used as a gauge to set a new

RPM SENSOR. The plastic tip is designed to

come off after the engine is started.

P–05193

–8–4–

853, 853H Loader

Service Manual

P–05192