Service manual

OIL PAN
Removal
Remove the oil drain plug and remove the oil.
Remove the fastening bolts and nuts from the oil pan [A].
Installation
Clean the surface on the oil pan and engine block.
Put Three Bond (TB–1207B) at the front and rear main
bearing caps (Item 1) [B] & [C].
Put liquid gasket on the oil pan surface area of the engine
block.
Install the oil pan. Install and tighten the bolts in the
sequence shown [D].
Tighten the bolts and nuts to 13–18 ft.–lbs. (19–26 Nm)
torque.
A
B–08953
C
B–08911
1
D
B–12200
853, 853H Loader
–7–81– Service Manual
B
B–08418
1
1