Service manual

CAMSHAFT (Cont’d)

Tappets (Cont’d)

Check the diameter of the tappets [A].

Standard – 0.511–0.5114 inch (12,98–12,99 mm)

Limit – 0.510 inch (12,95 mm)

Clearance between tappet and engine block bore as

listed [B].

Standard – 0.0012 inch (0,03 mm)

Limit – 0.0039 inch (0,09 mm)

Tappet Installation

Lubricate the tappets before installation.

Lubricate the camshaft bearings and journals. Install the

camshaft, carefully not to damage the bearings.

Install the camshaft gear. (See Page 7–76.)

Check the camshaft end play using a feeler gauge [C].

Standard – 0.0002–0.0045 inch (0,05–0,114 mm)

Limit – 0.0079 inch (0,20 mm)

After the rocker arm assembly is installed, make sure to

set the valve clearance. (See Page 7–41.)

B–08211

B–08216

–7–80–

853, 853H Loader

Service Manual

B–08212