Service manual

CAMSHAFT (Cont’d)

Camshaft Bearings

The tools listed will be needed to do the following

procedure:

MEL1260 – Camshaft Bearing Remover/Installer

Use the correct tool to remove the bearings [A].

When installing the new bearings, make sure to align the

oil hole in the bearing with the hole in the engine block

(Item 1) [B].

Tappets

Remove the tappets from the engine block. Mark the

cylinder number on each tappet after removal [C].

Inspect the tappets for wear, damage or abnormal

conditions [D].

B–08219

B–08190

B–08210

Pitted

Crack

Normal Contact

Irregular Contact

853, 853H Loader

–7–79– Service Manual

B–08220