Service manual

CAMSHAFT
Removal And Installation
Remove the rocker arm cover, rocker arm assembly and
the push rods. (See Page 7–56.)
Remove the timing gearcase cover. (See Page 7–71.)
Remove the camshaft gear. (See Page 7–76.)
Remove the oil pan and oil pump. (See Pages 7–81 &
7–82.)
Remove the camshaft from the engine.
Checking
Check the camshaft journals [A].
Standard – 1.9662–1.9675 inch (49,945–49,975 mm)
Limit – 1.9528 inch (49,60 mm)
Check the bearing inside diameter [B].
Standard – 1.9685–1.9697 inch (50,0–50,03 mm)
Clearance between camshaft journal and bearing:
Standard – 0.002 inch. (0,05 mm)
Limit – 0.0047 inch (0,12 mm)
Check camshaft run–out [C].
Limit – 0.0039 inch (0,10 mm)
Check cam lobe height [D].
Standard – 1.654 inch (42,02 mm)
Limit – 1.640 inch (41,65 mm)
A
B–08217
C
B–08221
D
B–08222
–7–78–
853, 853H Loader
Service Manual
B
B–08218