Service manual

CAMSHAFT GEAR
Removal And Installation
Remove the timing gearcase cover. (See Page 7–71.)
Remove the idler gear. (See Page 7–73.)
Remove the bolt at the camshaft gear [A].
Installation: Tighten the bolt to 72–87 ft.–lbs. (98–118
Nm) torque.
Install the puller and remove the gear [B].
Remove the bolts at the retainer plate [C].
Installation: Tighten the bolts to 11–17 ft.–lbs. (15–23
Nm) torque.
Remove the retainer plate [D].
Installation: Check the camshaft end play.
Standard – 0.002–0.0045 inch (0,05–0,114 mm)
Limit – 0.0079 inch (0,20 mm)
A
B–08931
C
B–08980
D
B–08979
–7–76–
853, 853H Loader
Service Manual
B
B–08932