Service manual

TIMING GEARCASE COVER
Removal And Installation
Remove the alternator and belt. (See Page 6–1.)
Remove the bolt at the crankshaft pulley [A].
Installation: Tighten the bolt to 123–152 ft.–lbs.
(167–206 Nm) torque.
Use a puller to remove the crankshaft pulley [B].
Remove the bolts which fasten the noise dampening
shield to the timing case cover [C].
Remove the noise dampening shield [D].
A
B–08945
C
B–08947
D
B–08942
853, 853H Loader
–7–71– Service Manual
B
B–08943