Service manual

TIMING GEARCASE COVER SEAL
Removal And Installation
The tool listed will be needed to do the following
procedure:
MEL1265 – Crankshaft Front Oil Seal Installer
Remove the alternator and belt. (See Page 6–1.)
Remove the bolt at the crankshaft pulley [A].
Installation: Tighten the bolt to 123–152 ft.–lbs.
(167–206 Nm) torque.
Install a standard puller and remove the crankshaft pulley
[B].
Use a screwdriver and pry the front seal out of the timing
case cover [C].
Use the seal installation tool and install the new seal [D].
A
B–08945
C
B–08946
D
B–08948
–7–70–
853, 853H Loader
Service Manual
B
B–08943
B–08983