Service manual

CRANKSHAFT GEAR

Removal And Installation

The tools listed will be needed to do the following

procedure:

MEL1263 – Crankshaft Gear Installer

MEL1264 – Crankshaft Rear Oil Seal

Use a puller to remove the gear [A].

Use the correct size driver tool to install the gear [B].

Clean the crankshaft and check that all the oil passages

are clean and open.

Clean the engine block, lubricate and install the upper

halves of the main bearings.

Put the crankshaft carefully in position.

Install the main bearing caps and bolts. (See Page 7–64.)

Check the crankshaft so that it rotates freely. Check the

end play. (See Page 7–66.)

Install a new rear oil seal [C]. Using the correct size driver

tool.

Lubricate the connecting rod bearings. Install the

bearings and rod caps. (See Page 7–62.)

Install the oil pump. (See Page 7–82.)

Install the oil pan. (See Page 7–81.)

Install the timing gears, timing gearcase cover and new

front seal. (See Page 7–81.)

Install the flywheel. (See Page 7–37.)

B–08249

B–08261

853, 853H Loader

–7–69– Service Manual

B–08250