Service manual

MAIN BEARINGS
Description
The crankshaft has five main bearings. The end play is
controlled by a thrust washer on both sides of the center
main bearing.
Each main bearing cap has an identification mark in
relation to the engine block [A].
The position of each cap can not be changed from the
original location.
Removal
Remove the oil pan. (See Page 7–81.)
Remove the oil pump. (See Page 7–84.)
Remove the bolts from the main bearing caps.
Remove the main bearing cap and remove the bearing
from the cap half.
Remove the top half of the bearing by pushing on one side
of the bearing half and rotating the crankshaft [B].
On the center main bearing, remove the cap.
Remove the top half of the bearing and thrust washers by
pushing on one side of the bearing and rotating the
crankshaft [C].
A
B–08256
FRONT
C
B–08255
–7–64–
853, 853H Loader
Service Manual
B
B–01865