Service manual

GLOW PLUGS

Removal And Installation

Disconnect the negative (–) cable from the battery.

Remove the electrical bar holddown nuts at the glow

plugs [A].

Remove the electrical connector bar [B].

Remove the glow plug from the cylinder head [C].

Checking The Glow Plugs

Connect the voltmeter to the terminal end of the glow

plug. Touch the other lead from the voltmeter to the

heating end of the glow plug [D].

The reading must be approximately 1.5 ohms. If the

resistance is zero ohms the glow plug has a short circuit.

If the resistance is infinite, the coil of the glow plug is

broken.

B–08957

B–08923

B–11571

–7–40–

853, 853H Loader

Service Manual

B–08919