Service manual

ENGINE MOUNTS
Removal And Installation
There is a kit available to replace the existing engine
mounts in older model 853 loaders.
Use the following procedure to install new engine mounts:
Remove the existing mount from the engine. Refer to
engine Removal And Installation for engine mount
locations.
Replace all four engine mounts (2 front and 2 rear).
Use the parts shown to install the new engine mounts [A].
Item 1 – Square Nut – Used on left side engine mounts
Item 2 – Hex Nut – Used on right side engine mounts
Item 3 – Mount Washer
Item 4 – Engine Mount
Item 5 – Tube Spacer – Front 1.47 inch (37,3 mm)
Rear 1.57 inch (39,9 mm)
Item 6 – Snubbing Washer
Item 7 – Mounting Bolt
Install the new engine mount as shown in the cut away
side view [B].
Tighten the mounting bolts to 90–100 ft.–lbs. (125–130
Nm) torque.
A
MC–01771
2
3
4
6
5
7
1
B
MC–01765
Engine
Mounting
Bracket
Engine
Mount
Spacer
Snubbing
Washer
Washer
Loader
Frame
853, 853H Loader
–7–39– Service Manual