Service manual

FLYWHEEL
Removal And Installation
Remove the drive belt. (See Page 3–1.)
Remove the bolts (Item 1) [A] from the flywheel.
Installation: Put LOCTITE on the flywheel bolts. Tighten
the bolts to 83–90 ft.–lbs. (113–122 Nm) torque.
Remove the flywheel from the engine crankshaft [B].
Flywheel Ring Gear
The ring gear on the flywheel is an interference fit. Heat
the ring gear enough to expand it and hit it with a hammer
to remove it evenly.
Clean the outer surface of the flywheel to give it a smooth
fit.
Clean the new ring gear and heat it to a temperature of
450–500°F (232–260°C).
Fit the ring gear over the flywheel. Make sure the gear is
on the seat correctly.
NOTE: Early S/N Loader does not have cooling fins
in flywheel.
A
P–04928
1
853, 853H Loader
–7–37– Service Manual
B
P–04939