Service manual

FAN GEARBOX (Cont’d)

Disassembly (Cont’d)

Press the bearing, shims and gear from the shaft [A].

Remove the key (Item 1) [B] from the shaft.

Assembly

Long Housing

Press a bearing on the short keyed end of the long shaft

[C].

Install the long housing on the shaft [D].

Be sure the bearing is seated in the bore at the lower end

of the housing.

Install a bearing on the long keyed end of the shaft [C].

Support the lower bearing and press the other bearing in

the housing until the bearings seat in the housing [C].

Install on the bearing, the same number and size shims

that were removed during disassembly [D].

P–03001

P–02961

P–02960

–7–22–

853, 853H Loader

Service Manual

P–02972