Service manual

FAN GEARBOX (Cont’d)
Disassembly
NOTE: When repairing the gearbox order the
following as needed:
Remove the fan and blower housing mounting plate. (See
Page 7–15.)
Long Housing
Loosen the set screws (Item 1) [A] and remove the pulley
(Item 2) [A].
Remove the long key (Item 3) [A].
Remove the four mounting bolts and the part number tag
[B].
Remove the oil from the gearbox.
AVOID INJURY OR DEATH
Wear safety goggles to prevent eye injury
when drilling or grinding.
W–2108–1186
Drill an 1/8 inch (13 mm) hole in the seal. Use a slide
hammer tool to remove the seal [C].
Remove the small snap ring [D].
1. Complete Assembly
2. Long Housing Assembly
3. Long Housing
4. Short Housing Assembly (See Note
Below)
5. Internal Parts
NOTE: The short housing is only available as an
assembly. See the Parts Identification Page
7–17 for reference. (Order parts from Melroe
Parts Sales.)
NOTE: Be sure to count the number and thickness of
shims during disassembly. Install the shims
in the original location during assembly.
A
P–03005
1
2
3
C
P–02999
D
P–02964
–7–18–
853, 853H Loader
Service Manual
B
P–02983
Part Number
Tag